Stop trash and debris from falling behind your pull-out bin.
Trash Shield is a simple clip-on barrier for pull-out trash cabinets that helps block the gap around the bin, so crumbs, scraps, spills, and debris go into the trash, instead of into the cabinet.
No tools. No adhesive. No permanent cabinet modifications. Patent Pending.
Why This Keeps Happening
Pull-out trash cabinets often leave open space around the bin, and that space catches the mess that misses.
The Gap Around the Bin
When food scraps, crumbs, or small pieces of trash miss the opening, they can fall into the exposed space around or behind the pull-out can.
Hidden Cabinet Mess
That debris collects inside the cabinet, where it is out of sight during everyday use but still creates grime, buildup, and frustration.
Hard to Clean
Cleaning it usually means pulling out the bin and reaching into a narrow cabinet space that is awkward and unpleasant to access.
Without Trash Shield
Scraps and spills miss the bin
Without Trash Shield
Debris collects inside the cabinet
How Trash Shield Works
Trash Shield clips to the edge of the bin and helps block the open space where waste can fall into the cabinet. Instead of dropping behind or around the bin, debris is better contained and guided toward the trash opening.
Trash Shield installed
Trash Shield installed. Clean and out of the way.
Large, Muted Red
Large, White
Large, Black
Large, Light Blue
Will It Work in Your Cabinet?
Fit is the first question most people have, so here is how to check.
Trash Shield may be a fit if:
- ✓ You have a pull-out trash cabinet
- ✓ There is exposed space around or behind the bin
- ✓ Your setup matches the supported cabinet widths and rail styles below
Works With
- ✓ Most standard pull-out trash can systems
- ✓ Single and double bin configurations
- ✓ Bottom-mount and side-mount slide rails
- ✓ Standard under-cabinet widths (12"–21")
Does NOT Work With
- ✗ Freestanding or pedal-operated bins
- ✗ Top-mount or door-mount trash systems
- ✗ Custom-built or fully enclosed cabinetry
- ✗ Round or oval bins
Which Size Is Right for You?
Trash Shield comes in three sizes. To find the right fit, measure the gap between the top of your pull-out bin and the underside of the countertop or cabinet above it.
Small (Muted Red)
2.5″ gap height
8⅝″ wide
Medium (Black)
3.5″ gap height
8⅝″ wide
Large (Light Blue)
4.5″ gap height
8⅝″ wide
Measure with the bin pulled out and level. If your gap falls between sizes, the smaller size is usually the safer choice.
Not sure if it will fit? Contact us before ordering and we'll help you check.
Common Questions
Stop cleaning the mess behind the bin.
If food scraps, crumbs, and spills keep ending up inside the cabinet around your pull-out trash can, Trash Shield offers a simple way to help stop it at the source.
Trash Shield is manufactured on demand in Boise, Idaho by our production partner, Portals by Slant3D. We handle the order, they handle the print and ship. Questions? Reach out.
About Trash Shield
Trash Shield started with a simple frustration: cleaning out the hidden mess that kept building up inside the cabinet around the pull-out trash can.
After seeing food scraps, debris, and spills end up behind the bin again and again, the problem became obvious. The cabinet needed a simple way to help keep that mess from falling in there in the first place.
Trash Shield was created as a straightforward add-on for pull-out trash cabinets. Simple to install, easy to use, and focused on solving one annoying kitchen problem well.